Rover Sports Register Forum

Hi Everyone,
I need to fabricate the Tunnel for the Gearbox for my P3 75.
Will need help with the pictures and also the dimensions.

Thanks
Kartik

Mike Couldry used to have reproduction ones in stock, have you tried him?

Hi
It should not be difficult to fabricate, getting it shipped from UK to India
Would cost me a lot.

Kartik

OK, best of luck. You do realise that it is made of rubber?

lakesrally wrote:OK, best of luck. You do realise that it is made of rubber?

Oops !!, I did not know that, , Thanks for the Info, I will get in touch with Mike Couldry.
meanwhile any picture of the same would be greatly appreciated.

thanks
Kartik

If I had my car here then I would gladly oblige but I cannot at the moment, sorry.

Hi Kartik

I've got to do some work on my P3 in the morning,
before I deliver it to its new owner, so I'll take some
photos of the tunnel and get the tape measure out
and email it to you.

Rgds, Chris C.

P3 Rover 75 - 1949
P2 Rover 14 - 1939

Chris C wrote:Hi Kartik

I've got to do some work on my P3 in the morning,
before I deliver it to its new owner, so I'll take some
photos of the tunnel and get the tape measure out
and email it to you.

Rgds, Chris C.

P3 Rover 75 - 1949
P2 Rover 14 - 1939

Thanks in advance ,

Photo's & drawings sent direct to you via email

Best of Luck, Chris C.

Thanks to Chris, for the effort in sending me the pictures, greatly appreciate it.
posting the pictures here for benefit of all Rover enthusiasts !!



http://s985.photobucket.com/user/kl1008 ... t=3&page=1

thanks again Chris.

Kartik