The measurements are as follows:
Front boards: 24" long front to back, 16" across at the front and 19" across at the back.
The hinged cut out door for access to the jacking point is 6.5" front to back and 5.5" wide.
Rear boards: 19" long front to back, 23" wide.
As per the photos on the previous message, you will need to trim some of the corners
and make cut-outs to get the wooden floor to fit correctly.
If you haven't already got one, you will need a piece of moulded rubber, to go over the gearbox
from the bulkhead to the metal seat base and the gearbox tunnel grommet.
These are available from Meteor Spares - Nottingham UK, Part No M000000264 and No. 71727
(stating year and model) at approx. cost £100 + delivery + VAT
Rgds, Chris C.
Rover 75 (P3) 1949
Rover 14 (P2) 1939
P3 floor boards
Re: P3 floor boards
Chris Cartmell - DVLA Liaison Officer
Rover Sport Register
1939 - Rover 14 Saloon (P2)
1975 - Rover 2200 Saloon (P6)
Rover Sport Register
1939 - Rover 14 Saloon (P2)
1975 - Rover 2200 Saloon (P6)
Re: P3 floor boards
Thanks for all the info, Chris C.
regards
Kartik
India
regards
Kartik
India